Any pet — the full member of family. To take care of that to him it was good in your apartment, it is necessary before the new inhabitant appears. The cat has to have a place where she will sleep also the objects suitable in order that it could sharpen claws. Make for it a lodge with a column and a stove bench. In a lodge the cat will sleep, from a stove bench — to survey the territory, and the column upholstered with suitable material is required for turning of claws.
It is required to you
- - plywood;
- - piece of a plastic pipe;
- - carpet for an upholstery;
- - corners;
- - metal corner for fastening;
- - PVA glue;
- - joiner's tools.
Instruction
1. Estimate the sizes of a lodge and stove bench. If you are going to do it before the cat appears in the house, look at the average sizes of representatives of the necessary breed.
2. For the top stove bench cut out a piece of plywood of 50х60 cm in size. Cut out the same piece and from a carpet. Paste over the top part of a stove bench with PVA glue. It is possible to take also any other glue which can connect a carpet and a tree. Consider that glue whenever possible should not have a smell, otherwise your creation can not be pleasant to a cat. It is possible to cut out a piece of a carpet more and to fix allowances from below by wallpaper nails. This only place in a lodge where it is possible to apply nails.
3. For a lodge it is possible to take a ready plywood box the sizes about 40х40х50 cm. In it it is necessary to make an opening. If there is no ready box, then make it. At first in a front wall cut the fret saw an opening. It can be round or square, about 15 cm wide. Screws attach sidewalls. Fasten a floor.
4. Paste over a lodge with a carpet from within and outside. Paste a carpet on an internal surface of a roof. Attach it screws to walls and paste an upholstery on the top part.
5. Take a piece of a pipe and attach to it from two parties metal corners. One party the pipe will fasten to a lodge roof, another — to the lower surface of a stove bench. You fix corners evenly on two perpendicular diameters of a pipe. Fasten it to a lodge roof. From above put a stove bench and too attach.
6. Wind a pipe with a rope. Make several rounds, grease a rope with glue. Let's dry out then again reel up several rounds. Grease with glue and them. Thus reel up and fix a rope up to the end. It is possible to use a bilateral adhesive tape. Instead of a rope it is possible to use dense fabric, having cut it on strips. Old jeans will approach, for example.