For each dog it is important to allocate the place in the house. It has to be somewhere in a secluded corner that the animal could have a rest there quietly. It is possible to equip such place with a soft and cozy plank bed where to your dog it will be pleasant, comfortable and warm. Pet-shops have a good selection of these products today, but you can make this accessory and the hands.
It is required to you
- - foam rubber
- - fabric
- - glue
- - holofiber
Instruction
1. If you want to make a plank bed for a dog with high sides, it will be required to you: furniture foam rubber 4 - 5 cm thick, glue for foam rubber, fabric for a covering, holofiber. At first cut out foam rubber on two details of the sizes necessary for you: a round bottom of a plank bed of suitable diameter, and a side from 20 to 40 centimeters high, depending on the pet's size, and length equal to bottom circle length. Take a long detail for a board, and cut off from its edges the top corners at an angle in 30 degrees that the entrance turned out.
2. Trying on foam rubber details, make a pattern on fabric, without forgetting to leave allowances for the seams equal to width of foam rubber plus two centimeters. At you four fabric details have to turn out: two round for a bottom, and two long for a board.
3. Sew a cover for round foam rubber, having left an opening to insert it inside. Push a detail for a bottom in a cover and sew up an opening.
4. Take a pattern from fabric for a board, and sew rags on the long parties. Push foam rubber in the turned-out sleeve. Close the turned-out board in a ring, stick together edges of foam rubber and sew up a fabric cover.
5. Connect a board and a bottom and fasten them with glue, the stapler or threads.
6. Sew a bedtick for a pillow which you put on a plank bed bottom. For this purpose find two round details with a diameter at 10 - 15 cm more than diameter of a bottom. Sew them with an iznanik, having left a small opening. Turn out a bedtick, fill it a hlofayber, sew up an opening and put a pillow in a plank bed.
7. If you do not want to do high boards for a plank bed, can sew it in a different way. You need foam rubber, fabric for a covering and a decorative cord. You will find a round or rectangular bottom of the necessary size from foam rubber and sheathe it fabric.
8. Further, if the plank bed is round shape, sew a sleeve 10-15 cm wide and at 20-30 cm long bottom circle lengths are shorter. Twist from foam rubber the roller diameter equal to width of a fabric sleeve and its lengths are 10 cm shorter. Push the roller in a sleeve so that since each end there were about five centimeters of free fabric. Tie edges of the roller a decorative cord and sew it to a plank bed bottom. If you decided to make a bottom rectangular, you should sew four soft rollers for each party of a bottom. The soft, cozy and beautiful plank bed for your favourite is ready!