Service jacket with spangles – one of the most popular and fashion trends. Such manicure looks very romantically, naturally and does not spoil appearance of nails. Professionals do service jacket with spangles in several stages thanks to what manicure turns out resistant, equal and beautiful.
Instruction
1. In order that the edge of nail (smile) has been painted exactly over, it is necessary to begin creation of manicure with it. Process nails, cuticles and near-nail skin. Give to nail plate the necessary form. After that apply white acrylic on edge of nail, forming smile. After this layer dries up, paint the nail rest with pink varnish. If you want your nail to have kept the natural color, just make substrate of transparent gel, without removing sticky layer.
2. After the first layer of manicure dries, apply on it transparent gel and wait some time until it dries up too. The sticky layer should not be deleted. If you did the first layer by transparent gel or varnish, then this stage can be passed.
3. Drawing spangles on nail will be the following step. The beginning manicurists often meet difficulties at this stage: spangles lay down unevenly, gather in lumps or are distributed where it is not necessary. To avoid it, some advise previously to mix spangles with acrylic in the ratio 2 to 1. It is very convenient to use for this purpose special palettes. Apply the gel mixed with spangles on nail, wait for its drying and remove surplus by means of sponge or rigid brush.
4. Other manicurists advise to apply dry spangles on not dried layer of transparent gel. For this purpose it is possible to use brush, the applicator for drawing shadows on eyelids, the Q-tip or tubule which is cut off at an angle. Gain small amount of spangles carefully fill them on nail. If you do not want spangles to have been distributed on all nail plate, apply on the area intended for them, transparent gel. The previous layer owes life to completely dried. After gel a little stiffens, excess spangles can just be blown off.
5. After gel with spangles dries, remove sticky layer by means of foam sponge. Use new sponge on each two-three nails. If it is polluted, the surface of nails will become opaque.
6. It was necessary only to finish modeling of nail and to put luster layer.