Setup of channels on the TV of Philips does not require special knowledge. It is enough to follow simple instructions. Automatic adjustment of channels allows to save time and to simplify setup process.
It is required to you
- Remote control panel of Philips
Instruction
1. Find on the remote control the button with the inscription "MENU" and click it. Select the section "Configuration" or "Settings" from the opened list.
2. Further pass to the Installations point. Select "Setup of channels". Then - "Automatic adjustment" and "Begin".
3. Further - "Reinstallation of channels". After that it is necessary to select any country in which there is an official system of broadcasting of digital cable television. At some TVs from back face there is a list of such countries.
4. Now select the section "Cable", "Installations". Before starting search, it is necessary to specify the transfer rate mode - "Manual" and to set transfer rate.
5. It is also necessary to specify scanning of frequency: fast or full. It is recommended to install "Fast scanning". You can select "Full scanning". It will take about 30 minutes, at the same time the following step does not need to be executed.
6. Set the mode of network frequency "Manual".
7. That not only digital links, analog links were found, put in a status "On". Further click "Is ready".
8. Now it is necessary to start search. For this purpose click "Begin" and wait for completion of search. Upon termination of it is necessary to select "Is ready".
9. Setup of channels is complete. For an output from the menu it is possible to click "BACK" or "TV". Pleasant viewing!