How to connect the Internet without stationary phone

How to connect the Internet without stationary phone

Several years ago the most popular way of connection to the Internet was carried out by means of stationary phone. Now all this can be made also without it. It is the best of all to use the modem or the physical communication line (cable, satellite, etc. communications).

It is required to you

  • Personal computer, modem

Instruction

1. To connect the Internet, select and buy the modem. Them there is a large number. Connect it via the special connector to your computer. Install the software, that is the driver. Usually the disk with software goes complete with the modem. If you had a desire to check whether the modem is correctly connected, come into "Control panel" through "Search". Select the section "Modems" and come into the Diagnostics tab. In a window click on "In addition". There will have to be information on your connection.

2. Set dialing parameters. Open for this purpose "Control panel" and come into "Modems" again. There is a General tab. Click "Dialing parameters". The window in which select the Pulse checkbox for the column "Dialing Type" will open. The modem is connected and installed the driver. Now it is necessary to be connected to the Internet only. Come into "control panel". There find "Network". Select the Add item and click on it a mouse. The window where find the Net board tab will open before you. Click "Add" again. Select in the section "Manufacturers" the Microsofrt tab, and specify "the controller of remote access" in the graph" Net boards". Click "Ok".

3. Click "Start-up" and select "Remote network access". Then click on "New connection". The window where enter the name of connection will open. A mouse click on "Further". Now configure network under specific provider. Right-click on an icon a mouse. Come into "Properties". There fill all necessary fields: "Server type", "Type of a remote server". Set "Additional parameters". Remove a checkbox about "An entrance to network". Come into "valid network protocols". There remove all available checkboxes protocols, except TCP/IP. You can not set the server address.

Author: «MirrorInfo» Dream Team


Print