The wireless internet gains ground recently. It also is clear – bothered to be entangled in the infinite wires everything and why if they were succeeded by wireless technologies long ago. They much more convenient also are more modern, however, as a rule, wireless devices are quite dimensional and allow to work with them only sitting at a table at home or at office. An exception is portable access points which the router which is finding room in a pocket is. If you decided to use this device, then can find the instruction for its setup below.
It is required to you
- Ethernet RJ-45 port (network interface card)
- There is at least one wireless IEEE 802.11b/g device
- The installed TCP/IP protocol
- The installed browser
Instruction
1. Make sure that your system conforms to requirements, necessary for installation.
2. From a compact disk install the necessary utility.
3. Connect your device to the computer, the router or a hub.
4. Place the device on a plain surface as it is possible above above the ground, but far away from direct sunshine and any metal designs and objects. Make sure that there are no transformers, fluorescent lamps, powerful engines, fridges, microwave ovens, etc. nearby. The device should be at distance of at least twenty centimeters from the person. Check that the cable length of Ethernet did not exceed 100 meters. By means of the utility which is attached to the wireless device execute the overview of networks – it will help you to arrange in the best way the device.
5. Connect one end of RJ-45 of a cable to Ethernet to port, and other end – to your computer.
6. Connect one block end of power to the socket, and another – to the DC-IN connector.
7. Remember that in each house and office there is a set of obstacles for wireless communication, such as walls absorbing signals. To provide the largest range of penetration of signals and connection speed, try to dispose the device closer to the active user. Configure data transmission rate manually.
8. If in your network there are several access points, then make sure that their areas of coverage are blocked that there were no ruptures of connections. Arrange the points using the same channel as it is possible further from each other, it will lower noises.