Now there is a huge number of the equipment intended for creation of wireless networks. Unfortunately, many of them possess too small cover zone.
It is required to you
- - USB extender;
- - copper wire.
1. For gain of the signal level and, respectively, the range of its distribution it is possible to use the most various methods. For a start just try to replace the antenna. The majority of routers and Wi-Fi of adapters possess the removable antenna. Get a detail of bigger value with the necessary connector and connect it to the equipment. Try not to install the router under a table or in the remote corners of rooms.
2. Sometimes it is possible to change parameters of the existing antenna independently. Disconnect it from the router or the adapter and remove isolation from one edge of the antenna. Solder to it a copper wire of the necessary length. Other its end can be connected to the directed indoor antenna. In this case even the metal curtain or even an aluminum jar will approach.
3. The described methods not always meet expectations because with their help it is possible to achieve signal multiplication for 20-30%. If you need to provide the high level of a signal in certain places, then use the make-shifts allowing to transmit a directional signal. In this case the case of the system unit perfectly will approach.
4. Remove one wall of the block and solder the end of a copper wire to the center of one of its smaller parties. Connect the second end of a wire to the router antenna. Install a block wall so that the party, free from a wire, was sent to a signal multiplication zone.
5. If you use Wi-Fi the adapter connected to USB port, then modification of structure of the device can damage to its stable work. In this case it is better to buy the USB extender of the necessary size. Connect with its help Wi-Fi the adapter to the computer and place the equipment in the right place. It will allow to move a source of distribution of a signal, having provided thereby high-quality connection in the necessary zone.