Amaryllis: ways of reproduction

Amaryllis: ways of reproduction

If you like this plant, then it can be made multiple copies independently. For this purpose there are several ways. It is not difficult to make multiple copies Amaryllis at all, the main thing to observe some recommendations.

Reproduction by seeds

It is necessary to sow fresh-gathered seeds right after collecting. They can keep viability of 100% only for 5 weeks, then it sharply falls.

To seed seeds, it is necessary to pave the way, to mix humus, the cespitose earth, the sheet earth and sand.

To fill the soil in landing container, to make grooves, to evenly spread out seeds and to powder from above with the soil layer 5 mm.

For the best germination the soil should be supported damp, temperature 20-23os

After emergence of the first two leaves, the seedling needs to be raspikirovat in pots, no more than 100 ml.

Vegetative reproduction

  • To separate children.

During summer change from pots to the open ground, the main bulb can have child. She needs to be separated and put accurately again in pot. In the soil there have to be leaves.

  • Division of bulb

Without getting bulb from the soil, it is necessary to cut off the top.

Then to make an incision bulb on four identical parts.

Between cuts to insert small needles, they can be from tree or metal.

For the best growth it is necessary to support bright diffused light. To water as required when the earth dries up a little. Surrounding temperature has to be up to 28 wasps

After each bulb has leaflets, they need to be seated in separate pots. 

Reproduction by section

To pick up bulbs in the diameter of 6 cm and more. To clean from all old, dry scales.

To cut off the top and part of collum.

Leaving bulb in vertical position, it needs to be cut on part. The quantity can be from 8 to 16 depending on the bulb size.

The received allotments need to be wetted in solution of fundazol for processing for half an hour. 

Then to put each allotment to the soil on 1/3. For the soil it is better to use mix of peat and it is poured in proportion 1/4. It is abundant to water.

Bulbs will be created not earlier than in 3 months.

Author: «MirrorInfo» Dream Team


Print