Today laminate became very popular. It has advantages over other sexual coverings. It and price component and simplicity of laying. Floor which is covered with laminatny covering looks very harmoniously and beautifully. In shops now the huge choice therefore it is easy to pick up laminate under interior of your apartment.
It is required to you
- - tape measure or ruler;
- - pencil;
- - hacksaw;
- - hammer;
- - spreader wedges;
- - paroizolyatsionny film;
- - film substrate;
- - laminate.
Instruction
1. Before beginning to put laminate, carefully prepare the basis, that is level floor.
2. If you have wooden floor, then pass problem places the grinder. Also check its rigidity. If boards begin to cave in even from the weight of the person, they need to be strengthened or replaced.
3. In case your gender concrete and at detection of any deviations put the self-leveled tie.
4. Technology of laying of laminate simple. You can absolutely begin with any side of the room. But that joints between boards were less noticeable, it is better to put covering perpendicular to window opening.
5. At first stretch substrate along all wall. Do not stack it at once on all perimeter as further it will be interfered with you very much.
6. Then take boards of laminatny covering and lay out along wall from them strip, at the same time connect them among themselves the front side.
7. Set the end of the first laminatny board to which you will adjust the second against wall.
8. That boards pretty densely adjoined to each other, adjust them the hammer. For this purpose take wooden level and put it from the front side to the end of board. Only not to crest, and over it, otherwise you can break board. Slightly knocking on level the hammer, adjust them to each other. So spread and adjust laminatny covering along all wall. At the end saw off board of the size necessary to you.
9. So, the front page stopped being spread. Now drive it into the corner, at the same time previously insert special klinyshka from all directions. Them it has to be long about one centimeter. For this purpose you can use the cut-off unnecessary piece of laminate.
10. Put the second strip also, only in advance saw off half of laminatny board and begin to put from it.
11. Begin the following strip with the whole board again. So at you it turns out that the laminatny covering lies on floor in the form of chessboard. It looks more originally and beautifully. At such laying the laminate resilience to various driving forces also considerably increases.
12. Further take the second put strip and entirely insert it crest into groove of strip which is densely driven into the corner. Do it at an angle in 20 degrees.
13. Collect by this image and connect all strips of laminatny covering, at the same time adjust them on all perimeter.