To buy good is still half-affairs; installation process is not less important at all. Incorrectly connected unit will bring set of problems which solution can run into money.
Choice of the place
The machine should not disturb the hostess during its classes in kitchen and also to family members, guests during meal. It is at the same time necessary to dispose the unit whenever possible closer to sink. Floor has to be equal that the machine had no distortions in any plane. That to check it, shake the machine and make sure that backlashes are absent (if necessary use construction level). If this rule not to observe, then shaking of the unit and, as a result, its fast exit out of operation is inevitable. Pay attention to power supply: the unit demands the separate ground outlet. If it is absent, then it is necessary to carry out electrical wiring to the location of dish washer in advance. It is also necessary to calculate distance to the sewerage: length of draining hose of the unit should not exceed 1.5 m; otherwise the engine of the pump will work with overload that will lead to premature exit it out of operation.
Connection of dish washer
For connection to plumbing and sanitary it is desirable to use the hoses going in set. If on input there is no general water filter, then it needs to be established at least in front of the unit. After the filter it is necessary to mount plug cock. Some models have connection to hot-water supply, however if you use houses (at the dacha) the separate water heater, then is better to connect the machine to cold water since in this case heating of water will cost cheaper. The drainage (draining) is usually connected to washing via the T-coupler; here it is important to sustain hose inclination that dirty water has not gone back to washing.
Connection of the electric power usually does not cause problems, but it is necessary to remember that the electric motors applied in the unit, the pump including have rather big power; therefore supply cable, the socket have to be calculated on the corresponding consumption of current. At the same time use of T-couplers, extenders is not recommended, - only the separate socket is necessary. Still the best option – connection directly to electric board; in this case the time cut-out on 16 amperes will be required. After all connections are finished, it is necessary to check the unit in the test mode. For this purpose start the machine without ware, but with cleaning agent. Check how water is filled in as it heats up as there is draining, drying. Do not lose sight also of tightness of the connected pipes, hoses. Having made sure that all are normal, it is possible to push the unit into place and to use "the civilization benefits".