Modern technologies and repair materials are so simple in use and are so effective that to perform houseworks most easily and pleasantly. And if to remember also notable economy which you receive, doing all work independently, it becomes even more joyful. Linoleum – the fine practical material for flooring combining set of good characteristics. You can put it and in the big square, having qualitatively welded its edges.
It is required to you
- - linoleum;
- - knife;
- - painting adhesive tape;
- - glue for PVC.
Instruction
1. You will work by method of "cold welding" at home, that is with use of special glue. Electric devices and difficult technique will not be necessary for you. Glue for connection of products from PVC on structure is close to composition of the linoleum at contact with which slightly it the edge dissolves and melts.
2. Clean working surface from dust and garbage. Vacuum and wipe with clean dry rag. Work with glue in gloves as its components are quite aggressive. After work surely air the room.
3. The edges of material need to be evened as much as possible, it can be reached, having only cut two pieces of linoleum together. Pick up the drawing and lay covering with an overlap. Sharp linoleum knife cut two layers at once. That the line was equal, put direct board, long ruler or tailor's meter.
4. Paste linoleum to floor that it did not move and was not deformed. Protect edges of material painting adhesive tape, it is especially important for glossy surfaces. Paste two strips if linoleum soft, and one if covering rather rigid. In the second case just cut through adhesive tape fine thin edge.
5. Take special glue for PVC and carry out by tube nose on seam. Means will get inside, will enter interaction with components of linoleum and will be polymerized. It is possible to apply the gluing structure in turn on two pieces of material, and then to join. Act as it is more convenient to you.
6. Anyway, delete the surplus of glue acting on adhesive tape surface not at once. Welding process still goes, and together with surplus it is possible to remove the structure participating in work. When means dries, it will be much easier to cut off it.
7. Cold welding can use and if you have damaged linoleum covering. Glue will close up cut so that there will be no trace left.
8. Clay for welding of products from PVC is two types: And yes Page. Type A is used for compound of new linoleum, type C perfectly closes up seams of old material which have already a little dispersed and are deformed.
9. Stick together much more densely on the consistence, the old seam sometimes has gap in several millimeters. If you deal with such problem, fill slot with S-glue. A-glue will melt and will weld pieces of new linoleum.