Installation of plastic windows is considered very considered decision now for owners of apartments or owner-occupied dwellings as such windows are famous for the hydro- and thermoinsulating properties. However sometimes occurs so that the windowsill begins to blow that leads to cooling of the room, especially, if it occurs in winter time at subzero temperature.
What to do when blows plastic window
For a start it is necessary to deal with that why it occurs. In case you feel that the joint of shutters probably the main problem in bad sealant blows. It should be taken into account the fact that even the most expensive profile of plastic window is not capable to guarantee you complete isolation against external weather patterns throughout big time. Generally sealant costs no more than 3-4 seasons, that is about 3-4 years of operation. After this time, sealant of window will become more rigid and will simply lose the initial properties.
Gradually in it there will be small slots through which cold air from the street will arrive. Exit in this situation will be one – purchase of new rubber sealant for window which can be got in any specialized shop. And completely to be quiet for the plastic window, it is worth buying him care product. In this way you prolong sealant life cycle for one or two seasons.
Their adjustment is one more frequent reason of blowing of shutters. In this case it is necessary to warm nothing. To define has sagged windows it is possible very simply – at its opening the lower part of shutter will touch frame. At the same time in upper part of window produva will be observed. To be necessary for you for correcting of accessories the hexagon and flat-nose pliers. On fitment binding you will find several elements – the top and lower loop, pin, reciprocal levels of window and scissors which generally are located on rotary and folding accessories. By means of the lower loop you will be able independently to make adjustment of window. Usually it is regulated in four directions – to the right, to the left, up and down. And the top loop supports adjustment on clip. It is also possible to expose the provision of window in the different direction (to the right or to the left). These elements as reciprocal levels and pin, will serve for correction of clip of shutter.
Air gets into the room through slopes
For a start it is necessary to remove slopes and in addition to warm window under them. In case there is polyfoam, carefully to zapenta polyurethane foam all joints and seams of the condensing element. Foam, in fact, has to adjoin densely on all area of window and its frame. In brick houses completely to exclude produva, advise in addition to plaster walls under slope heater. As the pressurizing material it is possible to use normal polyurethane foam.