The frame garage belongs to inexpensive and pre-fabricated constructions. Nevertheless at respect for simple technology the similar construction can truly serve not one decade.
The construction method of frame garage means construction of steel or wooden skeleton. Use of wood is not so expensive, but metal framework more reliable and will serve longer. Anyway the frame garage will cost considerably cheaper, than construction from mass concrete, blocks or brick.
Base
There are 2 options: plate or melkozaglublenny tape basis. In the first case it is necessary to clear away the site and to remove layer of earth on 30 cm deep into. Further it is necessary to make the decision on arrangement of viewing hole. If that is provided, then it is dug out and spread brick from within. It is in passing recommended to lay to hole pipe in half-inch in which stack electrical wiring subsequently. At the next stage it will be required to establish timbering which height is 20 cm on perimeter of the plate base. On the prepared site fill crushed stone layer in 10 cm and level it. Further flood the site thin (3 cm) with concrete layer on which lay reinforcing rods. After that it is possible to make final filling. For arrangement of melkozaglublenny continuous footing it is enough to dig out on perimeter of future garage trench width and 30 cm in depth. On bottom fill sand layer (5 cm) and crushed stone (10 cm). Further fill in the first thin layer, then lay armature and finally concrete ditch on perimeter.
Assembly of framework, roof and walls
If it is supposed to collect framework from metal, then at first weld, according to drawings, metal corners or profile pipe. The additional rigidity is reached at the expense of the metal flat triangles welded on position of joints of vertical and horizontal corners (professional pipe). After welding is finished, processes framework primer to protect from corrosion. The covering from sawn timber fastens to framework by means of self-tapping screws. The framework from tree requires bar of 100х100 mm (the bearing racks), and 50х100 (intermediate horizontal, vertical support). Vertical racks strictly fasten to the lower binding by means of steel corners plates and self-tapping screws. Also intermediate support are fixed. Step of vertical support – 50-60 cm. After the framework is ready, it is possible to start assembly of rafters (it is convenient to do it on the earth) from bar of 100х100 mm. To lift rafters, the assistant is required. Further it is possible to lay furring and to equip roof. Walls if desired warm mineral wool which is put between bars. Outside of wall upholster with carriage board or plates the VULTURE (Canadian technology). For internal covering it is possible to use chipboard or SMALLPOX (it is oriented - chip plate).