Temperature in the apartment depends not only on supply of hot water in struts, but also on radiators. If batteries in your apartment at the centralized heating hot, and it is indoors cold, it is necessary to add to radiator one or several additional sections taking into account the area of the room.
Instruction
1. In case when in the apartment remains cold even when giving in struts of water of sufficient temperature, at you it is necessary only – to add one exit section to the battery; if necessary use several additional sections. At first take radiator key and remove the established radiator entirely to check whether the battery as it is frequent in the room is hammered it becomes cold because of it. Remove the battery, accurately untwisting futorka radiator key, then carry radiator to the bathroom and give water jet there so that the arriving water came out the opposite end of radiator.
2. If the water flowing from radiator remains rather clear, it is necessary to add section to the battery as the cold reason in your room is in insufficient heat emission from radiator. Before that how to add section to the battery, visit specialized shop of plumbing and devices, choosing sections of the same type, as well as your radiator – bimetallic, pig-iron or aluminum. Irrespective of radiator type also threw of which it is made, it is possible to add section to by means of the same sequence of actions.
3. Untwist futorka on that part of radiator to which it is necessary to add additional section radiator key, prepare new section and put on the place of joint of sections connecting nut – the nipple. From each of sides of the nipple thread different therefore have the right part of connecting nut in relation to additional section, and direct the left side of the nipple towards the old, long ago established radiator. When it is necessary to add section to radiator, get on the nipple from two parties special intersection laying – gel, rubber or paranitovy that the battery did not proceed subsequently.
4. Nazhivlyayte on the nipple laying slightly, on the one side of connecting nut, then – with another, very accurately holding it with fingers. Pull together it carefully up, then down that at installation of new section to old radiator the laying "sat" without distortions. Tighten thread on the nipple radiator key slowly and evenly not to damage metal cutting until the nipple sits down" into place, and the battery will not be completely assembled. Hang up already collected radiator on kronsheyna and attach it to pipe, reeling up tow on pipe thread and fastening the battery to pipe thread normal wrench of the necessary diameter.