Each person daily consumes potable water. Our health and health depends on its quality. In order that directly in the apartment or office to drink cold and clear water, the cooler – the multipurpose drinking device is necessary. Getting cooler, it is important correct to establish it and to adjust, the durability of the device and faultlessness of its work will depend on it in many respects.
Instruction
1. Prepare plain and strong surface for installation of cooler. The installation site has to be dry and protected from direct sunshine. For good ventilation the distance between wall and the device has to make not less than 10-20 cm. It is not recommended to place cooler near expensive furniture and the equipment.
2. If the cooler long time was stored in the cold room or if it is got in winter time, let's it stand in the unpacked look 2-3 hours before connecting to network.
3. Adjust device cord length. To avoid short circuit of electrical wiring, do not undertake building of cord or replacement of wall plug. At installation of the device make its grounding.
4. Before inclusion of cooler in network fill it with water, at the same time control of amount of water has to be constant. Adjust water jet, make sure whether hot water continuous stream runs.
5. If after turning on of the new device the heating does not work probably the air lock has not been removed. Therefore for a start it is necessary to put large bottle on cooler, to wait, tanks will not be filled yet and air bells in large bottle will cease to rise. Open both cranes and merge from everyone on one glass of water for removal of air lock. Only now include cooler in network, otherwise the heating system will fail.
6. In the presence of leak of cooler replace large bottle. Most likely, the stopper is put on large bottles leaky, air comes to large bottle, and tanks are overflowed.
7. If water in cooler insufficiently cold, make its adjustment. The system of adjustment of cold water is on back wall. Adjust cooler up to the necessary temperature. If after inclusion of new compressor cooler water is not cooled, perhaps, the device was delivered not in vertical position. Let's cooler stand vertically and only after that include.
8. If in use cooler water from cranes began to flow badly, address for adjustment of the device to the service center.