Probably, at least once in life, but to everyone there was such situation: the flat key was lost, and there is no house anybody who could call that have opened door. Therefore one way out – to break the door lock.
- - office paper clip;
- - hammer;
- - plastic card;
- - penknife;
- - self-tapping screw;
- - nail-catcher;
- - drill with drill of 3 mm;
- - probe with magnet.
1. Unbend paper clip, having turned it into straight line. Then by means of the hammer distribute tip of wire a little and bend it at right angle. Carefully insert the master key made by the hands into keyhole and turn conductings: perhaps, not from the first attempt, but the lock will surely open. This way of opening of the door lock will approach in case at doors the cylindrical lock with twist handle is put.
2. Check wallet - if in it there is plastic card, then you are saved. Insert card into gap between cloth of door and box (this way of opening of the door lock will approach in case on door there is no level closing aperture between cloth and door case). You watch that the corner between the plastic card and the lock made ninety degrees. Press card to the handle of door and continue by it to carry out movements: change moving direction, carrying out by card on lock doggie.
3. If the Chinese door is established, then use penknife. Stick knife into door - it will pass very easily. Cut the lock, pull out it and open door.
4. Insert into opening for key the self-tapping screw and having hooked nail-catcher for hat, pull out the core of the door lock.
5. In the line of the connector of cylinder and the body of the cylindrical mechanism drill in bronenakladka slot for key. The drill has to go down that the support has turned out: it will be so much easier to drill. You drill before contact with the first couple of pins. Then over the first pin by means of three-millimetric mill make arch that will allow code pin to rise up. Take the basic lock by means of the probe with magnet. And then drill the lock up to the end.