When in the apartment small rooms, there is a wish that they were the coziest and comfortable. For this purpose it is necessary to exercise the wit in different ways, for example, creating nice interior in the bedroom by means of made own forces bed attic.
To make the bed leaning on four racks - business simple. At first it is necessary to develop the sketch of future bed with the indication of all dimensions. Such approach will allow to count the necessary amount of construction materials. The sizes of such design have to be defined by the metric area of the room or the available mattress.
The purchased wood materials should be sawn on pieces of in advance determined size, further in racks make slots in 30 mm for fastening to them fixing boards with the thorns of the corresponding parameters placed on them. They have to be inserted densely in the reciprocal openings prepared for them.
Mounting of product
Assembly of product is begun with back which connects to support. It is necessary to grease with joiner's glue each thorn and to hammer them into the reciprocal slots done on racks. In the same way do also opposite wall of design. Then it is possible to connect round loose tongues and bolts both backs in the middle to supporting girder. And it is better not to tighten bolts up to the end, then it will be easier to mount other structural components. As soon as this stage of work is completed, it is necessary to fix to level framework on each side at once and also to mount also the lower rails - under mattress. These elements fasten by means of joiner's glue. It is necessary to take care of reliability of product. That the child has not failed on floor, it is necessary to fasten under mattress not only cross, but also longitudinal bars. It is also necessary to think of bed boards as they have to be not less than 45 cm high.
Strengthening of design
For reliability of design, except the bearing support, it is necessary to add through each 30 cm also vertical crossing points from bars fastening levels of sidewalls to framework basis. For the best fortress the framework of bed is recommended to be fixed by furniture corners, or special bevels from small pieces of material, fastening with them rack with some inclination with sleeping framework that the triangle has visually turned out. Of course, it is worth thinking over question of production of ladder for such bed. For legs it is necessary to take couple of wide boards, to make on them saw cuts in 45 degrees. Further on board strictly parallel to saw cut it is possible to fix rails by means of screws, on them steps will keep within subsequently. For steps it is necessary to use stainless steel pipe or carefully ground bars, lacquered. That's all – the bed attic has turned out excellent.