How to construct brick garage

How to construct brick garage

Housekeeping Hits: 137

The brick garage is the most universal and durable construction. The brick garage is not afraid of the fires, floodings, cold weather, heat and winds. This actually eternal construction, whose "term of life" it is caused unless by quality of brick. The brick garage can be established on the base which needs to be done very thoroughly as the brick weighs very much.

It is required to you

Instruction

1. Dig out hole for the base the sizes of 4 by 6 meters. Its depth has to be not less than 60 cm, and width of 40 cm when digging precisely to vymerta corners of future building, they have to be 90 degrees. Fill holes about 5 cm of sand down. Prepare concrete solution from calculation: 1 parts of sand, 2 parts of sand, 1 part of crushed stone. Fill in this solution in base hole to ground level. Then put roofing material for waterproofing. Make several brick courses to make the base equal, at laying use level. Width of laying has to be in 2 bricks, that is 50 cm. From above make tie of cement slurry and again put waterproofing.

2. Now begin to spread walls from lime sand brick. Wall thickness has to be one and a half bricks. On the available base do laying exactly on the base from within, and outside at you the outflow for water about 10 cm wide will turn out. In front at once put gate, level them, fix by props, face bricks on both sides. Carefully you get corners, check them on plumb from two parties. Lay out garage walls to the level of gate from all directions. Over gate still put 5 rows of brick and begin to remove tilt angle to back wall of garage. Accurately level everything, make cement screed.

3. Cause hoisting crane, having rented it on working hours. Make roof of 4 floor slabs of 1 by 6 meters in size, having established them on walls. Bend loops on plates by means of which they are lifted. Prepare cement and sand solution, and make tie above roof not less than 5 centimeters thick. Grease all surface with bituminous varnish. Lay rubemast on all roof surface, warming its gluing surface blowpipe.

4. Fill up internal part of garage with crushed stone, without reaching the lower edge of gate of 6 cm. Fill in with liquid solution, level. Put roofing material or grease surface with bituminous varnish. Lay wooden floor, stacking boards not in length, and in garage width. On long edge of garage bring down them, having put on one board in corners. Put the lock. Here your garage is also ready!

Author: «MirrorInfo» Dream Team

Print