Some people dream of the boat to the flat-bottomed boat. However to get it they have no opportunity. Exit in this situation after all is available. It is possible to make the boat the flat-bottomed boat with own hands. On creation of such boat a lot of time and forces will not leave.
Instruction
1. For a start it is necessary to be engaged in assembly of framework. As building berth the wooden ox of your workshop is the best of all to use. It can also be made of boards which have thickness about 50 millimeters. As a result the board of 3500х1000 millimeters in size has to turn out. On building berth it is necessary to establish and fix keel bar by means of wooden linings. On it surely mark the planes of arrangement of frames. Further it is necessary to fix temporarily on keel bar frames. They have to be exposed on plumb and level.
2. Further it is possible to start installation of stringers of the bottom. Consistently adjust each of them to frames and fix by nails and epoxy glue. After the epoksidka finally hardens, it is possible to pass to further work.
3. To adjust stringers to frames and their fixing is recommended to be carried out in pairs. It is the best of all to begin with couple of internal stingers which are symmetric to rather longitudinal axle of the boat. If stringers have been steamed out, it is possible to fix them soft wire. After that they need to allow to dry well. On it several days leave. Then it is possible to fix by means of glue and nails.
4. The most difficult operation is connection of stringers with stem. At first it is necessary to make marking and to saw through groove in preparation of stem under keel bar. Then adjustment and connection of these parts is carried out by epoxy glue. After that it is possible to pass to marking and sawing of grooves in preparation of stem under the top stringers. These parts need to be stuck together. Connection of stem with other stringers is the same way carried out.
5. Further it is necessary to be engaged in fixing of covering on framework. At first it fix on the bottom, then on boards, and then already and on the deck. Before being engaged in covering, it is necessary to cover with several layers of hot drying oil internal surfaces of boards and the bottom. Then fixing on covering of free bars is carried out. After full hardening it is possible to start body vyshkurivaniye.