Toilet — the room for departure of natural needs (urination and defecation). In toilet the toilet bowl and other sanitary devices, for example, sink and bidet is located. Modern toilets are connected to the sewerage. There are also figurative toilet cabins and dry closets. Let's consider with you how to construct normal street toilet in owner-occupied dwelling.
It is required to you
- For construction of toilet it is required to you:
- - shovel (bayonet and sovok);
- - red brick;
- - cement;
- - sand;
- - 2 logs oak 1.5 meters long;
- - hewn eaves boards 1 cubic meter;
- - bar of 5 by 4 cm;
- - plywood 11 mm;
- - electrofret saw;
- - nails;
- - 1 sheet of slate.
Instruction
1. Choose the place where you will build toilet. It has to be somewhere in corner of your site, in the secluded place, at distance not less than 10-15 meters from the house. Mark hole 1 by 1 meter. Take spade and begin to dig. Remove the earth layers depth on shovel bayonet, periodically removing the earth square-faced shovel. Depth of hole has to be no more than 1.5 meters. If to dig it is deeper, then in the winter it will "soar" because of heat of the earth. When you reach depth about 1 meter, fill the earth in bucket, and your assistant, by means of rope, let takes out it on surface.
2. Prepare brick and make cement and sand mixture in proportion 1 to 3, that is 1 bucket of cement on 3 buckets of sand. Put the first row of brick in hole flatwise. Then to the very top lay brick on edge, accurately spreading it along hole walls. Above make plain surface on hole edge. Put the oak logs prepared by you with the equal surfaces squared above over hole, at distance of 20 cm from edges. Continue to lay brick now further, kind of immuring logs in laying. Height of laying has to be on thickness of logs.
3. Now take boards thickness not to exchange of 40 mm and make of them toilet floor, covering hole. Separate mentally toilet floor into 3 parts, in back part make square hole, cutting on half-boards. Its size is about 15 by 15 cm. Now beat bar on floor perimeter. At you the square will turn out, make framework of toilet lodge of bar, in front do not forget to make door opening. It is better to collect framework by means of the screw driver and self-tapping screws, but it is possible also on nails. Board everything, densely adjusting, them to each other. Make door, hang up it on loops, put door handles, hang up hook from within.
4. Start construction of the most important accessory – to so-called toilet seat. Bring down from thick plywood cube without bottom, with the parties of 40 cm Take normal toilet ring from toilet bowl, apply to upper part of cube, trace cut, saw through it the electrofret saw. At you the graceful opening turned out. Put this wooden toilet bowl over hole, fix obliquely by nails or self-tapping screws to floor. Buy in shop unitazny ring with cover, attach it to your toilet bowl. The last that you needed to make is roof. Put upward the sheet of slate, its standard dimension of 125 by 175 cm. Beat it slate nails. Your toilet is ready! To avoid smells buy special biological products for house toilets.