At the dacha not to do without toilet. But what to do if you have no means to employ crew of professionals? It is quite possible to manage by own forces. Only the patience, the minimum joiner's skills, quality materials and simple set of tools will be required.
- - bar of 100х100 in size;
- - bar of 50х50 in size;
- - plywood or chipboard;
- - slate;
- - sheet polyfoam;
- - screw driver or screw-driver;
- - hacksaw;
- - plane;
- - hammer;
- - nails;
- - self-tapping screws.
1. Before earthwork operations decide how the toilet will be cleaned. If you pump out by the vacuum machine, then do cesspool as it is possible more deeply. If you are going to clean by own forces, then the deep hole does not need to be done. At the same time dig through from backside small trench by means of which you in the course of cleaning will reach hole. During operation of toilet close trench old sheets of iron, boards, etc.
2. Think what size there will be your construction. The recommended parameters of country toilet such: width — about 100 cm, length — about 150 cm, height — 210 cm. It is the best of all to adhere to such sizes.
3. For giving of stability of design it has to be well buried to the earth. For this purpose it is necessary to hammer piles 90-100 cm long from four parties. For durability it is better to impregnate these support with water-repellent solution or to tar, then they will longer not decay.
4. Take wooden bar 100х100. Saw it by the sizes necessary to you and sew framework, connecting half-lap 50х50. If necessary grind and remove roughnesses of connections.
5. Further take bar 50х50 for sitting production. At the height of 50 cm from floor height crash it into the bearing bar. Make crossing point of the same material at distance about 100 cm longwise, beginning from back wall. And attach the same crossing point to back wall. Thus the basis for sitting will turn out.
6. Take the sheet of thick plywood or chipboard. Cut out opening that approached under the toilet seat size from it. By means of the normal screw-driver or the screw driver attach leaf.
7. Sheathe toilet walls plywood, chipboard or boards. To make roof, cut cross brusa and attach them to walls. It is possible to roof various materials: galvanized iron, wave slate, even roofing material. Now it was necessary to make door, to hang it, and the toilet is ready.