At independent repair of washing automatic machines it is necessary to remember that the order of their dismantling depends on the brand and model of the unit. For determination of the sequence of actions it is necessary to imitate any specific washing machine. For example, linen top-loaded machine.
It is required to you
- - flat blade screwdriver;
- - combination pliers;
- - wrench
Instruction
1. Turn off four fastening bolts located on the back panel of the machine and dismantle sidewalls.
2. Set handles of adjustment of temperature and switching of the modes to starting position. Turn off antirotation bolt on the control panel. Accurately press latches of decorative cover of the front panel, using flat blade screwdriver. Raise and dismantle cover.
3. Turn off two bolts located on each side the front panel. Squeeze by means of combination pliers and drown latch to which the plait of cables is attached. Unclench the fixing latches by means of flat blade screwdriver and dismantle the front panel of the washing machine.
4. Press plastic fixers of the doser of cleaning agents and remove it from the machine.
5. Unbend sealing rubber, turn off attachment bolts of cover of tank and dismantle it. Remove ring spring by means of flat blade screwdriver and extract sealant. Get stubs of hinges of door, using the slit screw-driver. Dismantle door.
6. Take draft cord from the slot, turn off four attachment bolts of cover of tank. Press the latches located on the back panel of the machine and raise cover a little. Take 2 tubes which are on the right side and cast away tank cover.
7. Turn off fastening bolts of upper part of tank and also screws on the left cross support.
8. Take off cone belt from pulley. Turn off antirotation bolt and take drum pulley.
9. Turn off the top bolts of the right crosspiece. Raise upper part of tank by means of the slit screw-driver. Repeat the procedure on the left side. Dismantle upper part of tank.
10. Turn off bolts of intensifying level, paying attention to their marking. The Roman digits specify much screwings up of bolts. Unscrew fastening bolts on each side and under level of the bearing crosspiece from two sides of the washing machine. Dismantle the bearing crosspieces.
11. Take out sealant from the slot. Press the plastic fixers located on tanks of tank and take drum.
12. Take filters. Dismantle hydrostat cover by means of the slit screw-driver. Remove terminals from TENa and turn off antirotation screw by means of wrench. Get heating coil.
13. Remove electric motor connectors, turn off attachment screws to the chassis and take electric motor.
14. Disconnect electric terminals of the drain pump, turn off attachment bolts and get the pump.
15. Remove the valve of the gulf of water, having removed its terminals and protective kyshka. Your washing machine is completely disassembled.