After installation in aperture and preliminary fixing by wedges of box with door the interval between outer surface of box and surface of aperture is blown by polyurethane foam. In 24 hours, foam hardens. The foam which has supported the box plane is cut off. Now it is necessary to establish door platband. It is possible to make it in several ways.
It is required to you
- Miter box, fair wood saw, copper tacks, hammer
Instruction
1. In traditional style the vertical and horizontal levels platbandof doors are joined at an angle 45 degrees. The platband fastens in such order: the left vertical, top horizontal, right vertical. Put long level in the miter box and cut off its face (level) hacksaw at an angle 90 degrees. Apply level of obnalichnik to door box the leveled face down. Note the place where it will be joined to horizontal part of platband on the right side of level. Cut off in the miter box on tag at an angle 45 degrees. Apply to box and check whether correctly you cut off platband level. Beat platband level to box copper tacks. Beat one nail from another at distance about 150 mm.
2. Apply the top horizontal level to box and note on it the line of joining with already established left vertical level. Cut off at an angle 45 degrees on the left side. Apply once again and note the place of joining with the right vertical level from the right bottom side. Cut off on the right side at an angle 45 degrees. Beat the top horizontal level of platband. Level face of the right horizontal level of platband in the miter box (cut off at an angle 90 degrees). Apply it to box equal face down. Note on it on the left side the place of joining with the top horizontal level. Cut off in the miter box at an angle 45 degrees. Beat level into place.
3. Levels of platband can be joined and at an angle 90 degrees. Such joining, for example, is applied when finishing in Viking style (semi-antique imitation). Installation order: the top horizontal level fastens, then under it side vertical levels of platband are brought. Apply the top horizontal level to box. Note on it arrangement of the outer edges of vertical levels of platband. Cut off level on these tags at an angle of 90 degrees. Beat the top horizontal level. Level faces of vertical levels. In turn apply them to box and note the place of joining with the top level. Cut off them on marks at an angle of 90 degrees. Beat levels to box.