Desire to improve the housing appears not so seldom. There is such need even more often. If you have decided to change outer door, it is not obligatory to order at all also installation which, by the way, costs expensive. Everything can be made independently.
It is required to you
- - tape measure;
- - level;
- - mounting tools;
- - drill or perforator;
- - water;
- - polyurethane foam.
Instruction
1. Very first that should be made even before purchase of door - to measure door opening. Usually they have standard dimensions, but will not be to specify definitely superfluous.
2. The beginning of installation should be considered preparation of door opening. At first it is necessary to remove old door. If there were difficulties, use force and try to pull out loops.
3. Now it is necessary to remove old door jamb. There are two ways. It is possible using - to beat out nail-catcher and sledge hammer it. But in this case there is high probability of damage of the aperture. More labor-consuming, but accurate method is the jamb perepilivaniye. Having chosen way and having realized it, carefully clean the released aperture from the garbage formed in work flow.
4. Further it is possible to start the installation. Unpack door, exempt it from mica and insert into aperture. Open at right angle to ensure scope for work. Will not be superfluous to ask someone about the help. The door needs to be recorded well - it is much simpler to make it together.
5. Now the door needs to be exposed on level. Even if will seem to you that it costs crookedly concerning walls, do not attach it significance. Quite often walls differ in surprising roughness. Lean only on what shows level, otherwise there can be problems with closing of door later.
6. It is necessary to establish further the party on which the door will be hung up. For this purpose use the perforator or drill, depending on type of your walls. The chosen electric tool it is necessary to drill the holes in wall corresponding to openings in box. In the formed deepenings wrap special anchor bolts. The main thing is not to draw them, otherwise it will bring down your door from level. Fasten bolts from both parties, in advance having checked how full box adherence to aperture will be.
7. It is necessary to grease places where you will process foam, water. Then strengthening will be stronger. Here the door is also established. Now it was necessary to wait when foam dries to cut off surplus knife.