It is necessary to approach installation of interroom doors extremely responsibly. In total you can independently perform works. Consider, at the slightest mistake your door will look crookedly, or at all will not be closed.
It is required to you
- - hacksaw;
- - self-tapping screws;
- - ruler or tape measure;
- - chisel;
- - hammer drill;
- - wooden bars;
- - wedges;
- - drill with special drills.
Instruction
1. For a start be engaged in mounting of box. Make cross crossbeam. Apply it to top of door and make measurements of distance which needs to be cut off. After that the same way saw off excess parts of two longitudinal crossbeams. Among themselves they can be fastened by means of self-tapping screws. Consider, between door and box there has to be gap in 4-5 mm. The door in this case will be easily closed and open.
2. After that you pass to insert of loops. At first cut loops in cloth. For this purpose you need to measure distance from the top and lower end of door on 20 cm. Apply loop and by means of pencil circle contour. Then under loop make dredging. For this purpose you can use chisel.
3. Put box to door and circle contour already on the box. You should not forget about gap in 4-5 mm. It has to be between door and the top crossbeam of box. It is the best of all to fix loops by means of self-tapping screws. Previously drill openings. Do it accurately. Otherwise the cloth can break up. Loops are left-side and right-hand.
4. At the next stage you have to install box in door opening. Place box in aperture and carefully level. If it is necessary, between box and aperture insert wooden bars. After that hammer wedges. In each rack of box drill three openings.
5. Remove box and on the tags which have turned out in wall make openings. For this purpose use the hammer drill. Install box into place and fix by means of long self-tapping screws. Their hats have to utaplivatsya in box. The gleam between door and cloth has to be 1-2 cm.
6. Then it is necessary to hang door on loops. Check whether well it is closed and opens. Further it is necessary to cut handles and the lock. For drilling of opening under the lock use drill with special drills. Put in this opening the lock with the handle. Once again open and close door.