Hinged cabinet – very convenient decision for small rooms. Most often such type of cabinets is used in kitchen. Establishing cabinet thus, it is necessary to consider that the loaded cabinet will be much heavier therefore all work needs to be carried out with special care.
It is required to you
- - extender;
- - hammer drill with magnetic nozzle and bat;
- - perforator;
- - drill on concrete of 6 mm;
- - dowels of 6х35 mm;
- - screws of 4х40 mm;
- - butt hinges;
- - drill on tree of 2.5 mm;
- - hammer.
Instruction
1. Examine spare parts to cabinet. First of all butt hinges (two on cabinet) will be necessary for you if they are not fastened at once by delivery of cabinet.
2. Fasten butt hinges to cabinets. For this purpose apply butt hinge to the top corner of cabinet so that the opening for wall screw in loop went over the edge of cabinet. Note pencil, and then drill opening drill on tree in plank end or chipboard. We put loops and we fix them by screws on the cabinet body, using magnetic nozzle to drill or the screw-driver.
3. Mark the provision of cabinets on wall. For simplification of marking, on table or table-top it is possible to deliver couple of stools, books on the necessary height, and to put cabinet from above. The provision of cabinet needs to be checked on level. If it is absent, then check, measuring distance from the established horizontal surface or from ceiling. Mark wall in the top opening of butt hinge.
4. Shift or remove cabinet. Get up on table or other steady support. By means of the extender connect the hammer drill or the perforator and drill two openings in wall on marking drill on concrete (better to drill not at right angle to wall, and with small inclination from top to down).
5. Hammer with the hammer dowels into the received openings so that they did not stick out. Move cabinet again into place and twirl screws in butt hinges up to the end, hanging up cabinet thus into place.