Anything to the person, it is possible to order in online store. In this regard many things sell knock-down, packed into boxes. Even cars can be assembled as meccano. Furniture is bought by spare part kit for a long time. To collect from them that it is necessary for you accurate instructions are necessary.
It is required to you
- - set of combined furniture;
- - fret saw;
- - saw;
- - ruler;
- - pencil;
- - fixture.
Instruction
1. Put table-top the necessary party on floor cabinets, leave gap in 5 millimeters at back wall and as much at side wall or case. If the set of kitchen furniture has the-shaped form, two sections of table-top connect end-to-end, but not corner.
2. Measure length necessary to you on the established cabinets and compare to table-top length. If it is necessary to cut off excess piece, make tag pencil and draw line. During the further work as hacksaw you draw on face side, and when using sawing machine – on the return.
3. Take crenulate saw if you work manually. Paste painting adhesive tape over piece which you are going to saw off that small pieces did not fall off. When using circular saw turn table-top reverse side up and put test ruler on material to cut off exactly. Process the turned-out edge abrasive paper that there were no splinters.
4. Establish table-top correctly and on the lower part note arrangement of floor cabinet easier to define the space for washing. Invert washing, put it exactly and outline pencil. Read the instruction from this plumbing and, on the basis of read, draw line inside.
5. Put table-top on two stools, having left between them the place which you will cut. Drill drill opening sufficient for operation of the fret saw. Cut the space for washing.
6. Apply polyurethane layer on cut to prevent water ingress in table-top. Establish washing, following indications of the instruction.
7. The set of fastenings is applied to table-top, put covering with their help. Put table-top as did at the beginning of work, with the same gaps. Plan places for fastening through equal intervals, drill openings under fixture. Fasten accessories to table-top and floor cabinets. By means of the screw-driver finish work.