There pass those times when linen was dried on the ropes tense between the hammered nails. It is much more convenient to use ready metal floor or suspended dryers which allow to hang out compactly wet linen in the most unclaimed places of the apartment – in corners or under ceiling.
It is required to you
- - dryer;
- - drill;
- - plastic or wooden traffic jams;
- - screw-driver or screw driver.
Instruction
1. Prepare the place for fastening of the dryer, carry out the analysis of ceiling and walls. If under external thin wall there are emptiness or pieces shower plaster, find more reliable place as under the weight of crude linen all construction can just fail. The best surface for fastening of the dryer – concrete or strong wooden bars.
2. Make marking on ceiling and wall, considering the sizes of the dryer and desirable arrangement. Carefully verify perpendicularity concerning walls and arrangement of brackets and bracket at one level. Double-check whether will interfere linen with opening and closing of doors, easy access. You should not install dryers in rooms where often smoke as linen will constantly smell of smoke.
3. Take brackets with rollers and by means of screws fix on ceiling. In concrete wall previously drill opening of large diameter, then hammer into it with the hammer plastic or wooden traffic jams. Apply bracket and by means of the screw driver twirl screws (they have to go in set to the dryer).
4. At the height of 1.2-1.5 meters from floor on wall fix the fixing bracket, having fastened it screws.
5. Take cords and miss them through rollers on brackets. Pay attention, on each crossbeam two cords, short has to go to fastening on wall at once, and long – it is hooked for roller on the party, opposite to fastening, then stretched parallel to crossbeam to wall and goes down to the fixing bracket. Thus, the fixing bracket will have two ropes of identical length. Then pass them through cap for reliable top fixing. Stretch cords through the cap intended for fixing of the lower position.
6. Check correctness of installation of the dryer. By means of caps the provision of crossbeams has to be regulated easily. Wipe crossbeams with wet towel wipes, establish them parallel to floor and begin to use.