The comfort and cosiness of the house in many respects is defined by decorative accessory of windows. Vertical blinds can give to window openings esthetic identity. Such protection against excess light not only allows to create indoors the optimum mode of lighting, but also well decorates interior. That blinds regularly performed the function, they need to be attached correctly.
It is required to you
- - measuring tape measure;
- - eaves;
- - fastening elements;
- - screw-driver;
- - power drill;
- - drill.
Instruction
1. Before getting vertical blinds, previously measure floor-to-ceiling height and determine the sizes of window opening. It is required in order that subsequently it was not necessary to change completely the device as it will be very difficult to change length of ready lamels any party.
2. Define way of fastening of the device. Blinds can be established in window opening and also before it, having attached to wall or ceiling. The product will be best of all to look when fastening is carried out on outer side of aperture and blocks window on each side approximately on 100-150 mm. Extreme lamels have to cover a little wall on both sides from window.
3. If you intend to establish blinds in the space limited on both sides, for example, in window opening or between two walls of the room from the measured width take away about 20 mm. The fact is that room width in the lower and upper part can differ slightly therefore the rooms of blinds which are picked up or made after measurement can not be located in aperture.
4. Prepare special clip-on earrings and brackets for fastening of the device. Usually they go complete with finished product, but sometimes it is required to get accessories separately. To attach blinds to ceiling or in window opening, use special clips which are kept by screws. Having established clips, insert into them eaves and latch.
5. If you want to hang up blinds on wall, use any normal bracket or standard, being included in the delivery package. Attach bracket to wall screws, and by means of bolt and nut attach clip to it. Insert into lamel eaves. In the presence in design of small weights establish them on the lower ends of lamels and connect chain.
6. Having established blinds, check them for working capacity. The described ways of fastening allow to shift slightly after assembly of design eaves in any given party if in it there is need.