Pasting of the room wall-paper from floor to ceiling – traditional way of dressing of walls. Applying various design decisions with use of combinations of different wall-paper and borders, it is possible to achieve originality of interior, to give it special chic.
It is required to you
- To issue walls in this way, two types of wall-paper and border are necessary. The border is wide (about 20 cm) strip, the same tone, as wall-paper.
Instruction
1. Before pasting of wall, it should be prepared. All defects in the form of cracks, chips, the departed plaster need to be removed, zashpatlevat and smoothed out for receiving plain surface by means of abrasive paper.
2. It is necessary to glue border and wall-paper on the wallpaper glue divorced according to the instruction. Surely fill up dry mix in water, and not vice versa, differently you risk to receive lumps of dense glue which to dissolve very difficult. In 20-30 minutes, glue is usually prepared for use. There is also glue which needs to stand 24 hours. In this case, prepare glue a day before pasting.
3. While glue bulks up, it is necessary to mark wall. With standard room height it is better (250-260th) to paste border at the height of 105-110 cm from floor. Make at some distance of tag by means of construction level and connect them 1 line. The horizontal position of the line needs to be observed surely, otherwise the border will only emphasize difference of height.
4. The border is glued first of all. Both the wall and border is for this purpose smeared. It is put to corner of one wall, having combined bottom edge with the outlined line, and paste, pressing the special roller. It is impossible to stretch border at sticker, otherwise when drying it will pull edges that can lead either to unsticking, or to damage of border. The border is conducted without interruption to the following wall.
5. When the border captures all perimeter of the room, start gluing of the top wall-paper, leveling strips by means of plumb. That not to smear border with glue, at the edges of it paste over with painting tape. All uneven edges are cut after full drying of wall-paper by means of metal ruler and office glue. The same way paste the lower part.