During campaign to utilize glass garbage, at home, to cut glass, or in garage safely to remove tinted film, it is necessary to heat glass surface. In each case different methods are used.
It is required to you
- - matches, lighter;
- - soldering iron, hair dryer;
- - triangular file;
- - water;
- - hammer, stone, heavy stick.
Instruction
1. If you need to replace glass in window, buy glass to insert it into window frame. As a rule, it by the sizes will appear more. Adjust glass by the necessary sizes. For this purpose put glass on plain surface. Make triangular file with edge notch, in that place where there will pass the cut. Recede on several millimeters from the made mark. Heat glass until until on the place of expected section the crack appears. Move the soldering iron so that glass has heated up on all length of cut.
2. To get rid of glass garbage, make fire - make it far away from the parking lot. Wait when the made fire inflames that it could not fade from wind gust. Put in advance collected glass jars in the center of fire, then roll out them by means of stick or any other long subject. It is necessary to pull out ware when you see that it was heated and deformed from fire. Further I will strike it is necessary to pour over the glass heated bottles or banks water. After such procedure, glass will crack on small fragile pieces which are absolutely harmless. Further, to receive glass sand, collect collected pieces and crumb by means of the hammer. Dig the garbage received in such a way - it will be safe for the surrounding nature.
3. When you need to remove film from automobile glass, heat its surface the hair dryer - it becomes evenly, to room temperature. Find edge of film, hook fine edge and tear off from glass, but without sharp movements.