Heat-insulated floors are fine alternative to usual heating, in many foreign countries such heating is used long ago and successfully. Heat-insulated floors are especially necessary in the bathroom, it is unpleasant to leave bathtub or from under shower on cold floor. On any heat-insulated floor - water, cable or film - it is possible to stack tile. The main thing to follow at the same time several rules.
It is required to you
- - Tiled glue;
- - finish for tile;
- - toothed palette for uniform putting solution;
- - small rubber palette for finish of seams;
- - plastic crosses for providing equal seams;
- - level, wooden rail.
Instruction
1. After mounting of heat-insulated floor and check of its working capacity make on it tie of cement and sand solution. If floor water or cable, then just you fill in it with solution. Lay nonmetallic assembly grid on which do the fixing tie hardly covering grid on the film floor. The second way for film floor - over film it is possible to stack gipsovolokonny leaf which is fixed on primary tie by dowels. Calculate step not to damage film.
2. After full drying of tie on it or according to gipsovolokonny sheets begin to stack tile as usual: dissolve tiled glue for heat-insulated floors, apply it on the site of floor of 70х70 cm and on tile with the toothed palette, lay tile on the floor, pressing and leveling it. That seams were equal, insert plastic crosses between tiles. After alignment of the site by means of rail or level pull out crosses until glue has dried. After laying of all tile leave it for day.
3. Next day make finish of seams by means of the rubber palette small sites - 1 sq.m. You watch that the finish well filled seams. Then wipe tile with sponge.
4. Include heat-insulated floor not earlier than full drying of tiled glue and tie under tile - there have to pass not less than 3 weeks. The term of drying of tiled glue is specified by the producer on packing.