Use of gas-silicate and other masonry units at construction of houses and various constructions is very widespread. But in view of the fact that these construction materials not always of ideal form, their additional alignment quite often is required.
It is required to you
- - construction level;
- - hammer;
- - cord;
- - grinding board;
- - tape measure;
- - blocks;
- - pencil;
- - hacksaw;
- - hand saw;
- - plane.
Instruction
1. The initial stage of masonry works means performance of the following operations: marking and laying of the foundation of the building and also laying of the most gas-silicate block (begin to carry out laying with the highest corner of house footing with the subsequent alignment under one level). Level masonry units by means of the hammer: slightly tap on blocks, setting them to the necessary position, and then check level flatness of laying. Not to check separately each block, stretch on level cord along future row and lay out, being guided by it, the first row of gas-silicate blocks, then the second, etc.
2. If during laying of masonry units on outer side of wall defects were found, correct them by means of grinding board. Carry out on the wall by this tool: it will clear wall of the speaker of glue and other visual defects which are evident.
3. In case during laying the gas-silicate block of irregular shape was necessary or it was revealed that one or several masonry units have the defective form, to adjust this material to the necessary form and the sizes it is simple. Make marking on the block and, having used the hand saw or hacksaw, saw off excess pieces.
4. You can level the acting parts of gas-concrete blocks also by means of special plane for gas concrete. On exterior this tool is very similar to normal carpenter's plane, but it only externally. In this plane there are two parties of segments, in each of which on five elements: blocks of segments are located at an angle to wooden site thanks to what this tool is ideal for work with gas-concrete blocks.