Angular computer tables are practically ideal for small rooms. They occupy minimum of the place and at the same time are very convenient in operation. The price of ready angular computer tables is rather big. Meanwhile, practically any person having the minimum experience with wood can make such table the hands.
It is required to you
- - electric fret saw;
- - flexible edge;
- - flexible U-section;
- - hexagonal wrench;
- - euroscrews;
- - plates of chipboard;
- - drill;
- - runners for the sliding shelf;
- - clowns;
- - supports under disks;
- - false legs;
- - fineliner;
- - square;
- - ruler;
- - pricker;
- - abrasive paper;
- - stationery knife.
Instruction
1. Determine the necessary sizes. Make the drawing of angular computer table with the detailed detailing.
2. Transfer the drawing to plates of chipboard and make cutting of parts by means of the electric fret saw. For this purpose trace at first part contour by means of fineliner. Make sure of correctness of the put marking. Plan part contour by means of pricker. Make cut on outer side of the line, having left 1-2 mm for operational development.
3. Paste flexible U-section on regiment under the keyboard, table-top, sidewalls and the shelf under the monitor.
4. Take flexible edge with the glue layer applied on it and paste over with it faces of other parts. It is possible to paste this edge by means of the iron. When gluing edge it is recommended to use the sheet of paper to avoid overheating of material and formation of bubbles. If necessary, cut off surplus of flexible edge by means of sharp stationery knife. Level cut by means of abrasive paper.
5. Plan by means of the square and line of opening under fixture. It is necessary to consider that for reliability of fastening of opening have to be located at distance of at least 4 cm from edge of parts.
6. Connect detalisnachal collect supports under table-top. Attach them to table-top by means of euroscrews. It is necessary to consider that when twisting euroscrews in chipboard, it is not necessary to turn them more than 3-4 times. At the bigger number of turns the euroscrews begin to be scrolled in material. Connect the shelf which will be located over the monitor, with corner posts of computer table and attach this design to table-top. Fasten the shelf under CD, the shelf under the keyboard by means of 4 clowns. Your angular computer table is ready.