Recently krasivotsvetushchy ampelous plants gain the increasing popularity in our country. It is promoted by continuous emergence of set of new grades of ampelous petunias, balsams, geraniums, fuchsias and other plants. The original vertical flower bed in the form of column from such plants which it is simple to make with own hands will become effective decoration of your garden or porch during all summer season.
It is required to you
- - big ceramic flowerpot;
- - wire mesh;
- - dense black film;
- - scissors on metal;
- - knife or scissors;
- - seedling of plants;
- - soil.
Instruction
1. We give to wire mesh the form of cylinder which diameter corresponds to the pot size. The surplus of grid is cut off by scissors on metal, having left has reserved about one long section. It is necessary in order that the design was strong.
2. We connect both parties of cylinder by wire in each section so that the flower column after filling by its soil remained steady. After fixing of horizontal seam, insert cylinder into pot. Check whether parameters approach. Height of the part of wire cylinder acting from container cannot exceed height of the container more, than by 3 times. Otherwise the design will be unstable. If the cylindrical framework after all has turned out too high, cut off it scissors on metal.
3. To learn how many it is required to us films, it is necessary to envelop it framework outside and, having left stock the size equal to the size of wire section, to cut off superfluous. Then we cover film cylinder from within, having placed its edges with an overlap that soil did not pour out.
4. From above cylinder we pull out surplus of film outside and we fasten its inside layer to external wire, at the same time tying to wire frame.
5. Let's start filling of design with soil. Having filled the third part of framework with soil, it is necessary to water well it that the soil has sunk. We fill up one more part and again we water. We repeat our actions and we stamp soil.
6. Also we fill up the soil between walls of flower container and framework, carefully stamping for bigger stability.
7. By means of knife we do crosswise cuts in film, having them in chessboard order through one section of framework. In these openings we will plant plants. We leave the lower row about pot without cuts that lashes of plants could hang down for edge of container, forming beautiful cascade.
8. We plant the chosen plants in the prepared cuts, watching that the soil could not get enough sleep freely from column when watering.
9. That our original flower bed was magnificent, in upper part of column it is necessary to plant several plants.