The human nature can surround itself with beauty. Special esthetic pleasure to us delivers species of flowers. However the period of their blossoming is so short. To keep joy for a long time, handymen have thought up method of copying of flowers from paper.
It is required to you
- - small scissors, it is better with the bent ends;
- - glug – special curve blunt knife without edge for production of flowers;
- - scissors of the average size with one wide rounded-off end that it was possible to use in quality glugs at its absence;
- - rubber of average softness, about 10х10 in size;
- - paper (it suits from sketchbook);
- - fine wire the size the 15-20th (it is possible to receive it if to remove cover from telephone wire);
- - cotton tampon;
- - water-based or other paints;
- - any glue for paper.
Instruction
1. To make paper flower, it is necessary: To put square from paper on diagonal, the segment in which corner there will be center of preparation of flower will turn out.
2. On the put paper, in 3 cm from the center to draw arch (as though it was necessary to cut out circle from paper). On arch to draw lobes of future flower. For sample it will be camomile. To choose lobe width about 7 mm, with the rounded-off or sharp end. It is good to trace only the ends of lobes, and to leave all length to core integral.
3. To scissor preparation by small curves.
4. Having unrolled, to cut through preparation between lobes, without reaching the center of 0.5 cm. Separate lobes of future flower will turn out.
5. To put preparation on rubber, softly pressing gurgle or the rounded-off end of scissors, with effort to draw the pressed line on the center of each lobe. The lobe has to be bent obediently behind knife, getting beautiful volume form. It is important to calculate correctly effort that preparation has not torn and did not slide on rubber.
6. To prepare flower core: small tampon of cotton wool to wind and fix by wire. To do approximately as do pompon of threads. Surplus of cotton wool to cut off and paint yellow color.
7. Having punctured hole with needle in the center of preparation of flower, to put on it the prepared stalk with core so that lobes were unbent outside. To grease core with glue in position of joint with preparation and to press to it flower.
8. To paste over stalk on spiral with thin strip of green paper and to attach leaves. It is possible to make paper flowers terry if to core to paste 2-3 preparations of flower from velvet paper.