Among the people the self-made power-saw bench enjoys wide popularity. Such popularity is reached generally thanks to ease of production. Collect self-made power-saw bench most often hastily, at the same time use low-quality metal.
1. On the tire of saw attach special frame which is made of metal. Thickness of board is defined by gap between frame and the tire. The self-made power-saw bench serves no more than three months as cheap materials are used. They begin to fail.
2. Take rails from corner which length is 50 millimeters as basis of power-saw bench. Establish it by the party up. Much attention is paid to installation of wheels. They should not be erased about corner. Most often installation is carried out corner edge up. In this case wheels are not erased. As "cross ties" use profile pipe of 25х25 millimeters in size. Between profile tube weld half-inch pipe on which there have to be log fixtures in the form of nails. Fixtures have to move and bend freely. The clip of tree has to work after the blow by the hammer on fastening is made. The clip samozaklinivatsya.
3. Profile tubes are used as rails. On ledges adjusting bolts which have M14x100 size of millimeters are placed. On profile tubes "bridges" are installed. On them logs will keep within. Last two "bridges" are located at distance of 50 centimeters. It is necessary for togas that it was convenient to place short preparations.
4. Original pulleys have diameter of 30-32 centimeters. Their grinding on turning lathe is made. The put-on belt after this operation has to act on couple of centimeters. The body of pulleys is welded on tubes. The design has to move freely on the horizontal guide made of half-inch pipe. It can be fixed by bolts. The right pulley has to stretch automatically. For this purpose it is necessary to establish spring from the shock-absorber. The left pulley has to be fixed. However it can move at change of the size of belt saw. Pulleys are established in parallel. However in order that the tape did not fly, they are carried out with inclination in 3 degrees.