Putty for tree is the special structure intended for seal of small slots and cracks and also for alignment of wooden surfaces. To make such structure quite perhaps independently, in house conditions. How to make putty for tree?
It is required to you
- - the crushed pumice - 30 grams;
- - gelatin white - 20 grams;
- - drill - 12 grams;
- - solution of 25% of ammonia - 18 grams;
- - casein - 20 grams;
- - linseed oil - 280 grams;
- - turpentine oil - 60 grams;
- - rosin - 200 grams;
- - ozokerite - 400 grams;
- - yellow ochre - 400 grams;
- - water - 290 ml;
- - pan;
- - metal capacity for mixing;
- - electronic scales;
- - palette;
- - brush;
- - PVA glue;
- - colourless lacquer;
- - sawdust.
Instruction
1. Take electronic scales, weigh and prepare necessary amount of ingredients. Take capacity for mixing.
2. Oil putty for derevapolozhita in in advance prepared metal capacity pumice. Fill in it with linseed oil, add turpentine and carefully mix. In turn enter gelatin, casein, ammonia into the received mix and to drill, carefully mixing each ingredient. Pour in necessary amount of water. Take pan of suitable volume and boil in it water. Place the container with the prepared mix in pan so that their bottoms did not adjoin. Heat mix to 90 degrees, continuously stirring slowly. Bring it to consistence of uniform paste. Apply still warm paste on wooden surface, using the palette.
3. Waterproof pitch shpaklevkaakkuratno melt earth wax (ozokerite) and rosin in suitable capacity. Carefully mix mix. Add yellow ochre parts, at continuous stirring. Apply hot homogeneous mass on wooden surface by means of the palette. It is necessary to know that when cooling this putty hardens. Therefore before the following drawing it needs to be heated to melting temperature again.
4. Perhaps, the easiest way of production of putty for tree is uses of the small sawdust which has remained after processing of wood on the grinder. Mix sawdust with PVA glue or suitable colourless lacquer. Apply on surface by means of brush or the palette.