How to make the antenna of beer cans

How to make the antenna of beer cans

In spite of the fact that the cable television in the last decades became very popular, many prefer to catch transfers from air. The good antenna which sometimes costs quite much is for this purpose necessary. But the antenna can be made and, at the same time the quality of reception will not be worse. Self-made antennas are especially necessary in houses where the quality of reception very bad or the TV in general refuses to accept something on the store antenna.

It is required to you

  • 2 pothouses banks
  • stick 30 — 50 cm long
  • cable
  • antenna plug
  • adhesive tape
  • 2 self-tapping screws
  • screw-driver

Instruction

1. Find the middle of stick and mark it. Equally spaced from the middle put beer banks upper parts to each other and densely to primotayta their adhesive tape. The distance between them has to be not less than 75 mm. Twist self-tapping screws in tops of cans.

2. Cut off piece of cable 3-4 m long. On that end of cable where there is no plug, make an incision the top protective layer. Remove it approximately on 10 cm from edge. Twirl silvery layer so that the branch from core has turned out. On core there is still average protective layer which needs to be cut off on 1 cm from edge. If you have no special television cable, anything terrible. In the same way cut off top layer and smooth out the ends of wire.

3. Disconnect bunches of wire and fasten to self-tapping screws. If you have special television cable, to one bank fasten cable core, and to another — silvery shielding. It is better to fasten cable to keys, but it is not obligatory.

4. Primotayte cable to stick. It is not obligatory, but it is better that the antenna has not collapsed at midpoint. Therefore it is necessary to primatyvat quite densely.

5. Thrust the plug in the TV on pass with the antenna across the apartment. Define the most suitable place and fix the antenna.

Author: «MirrorInfo» Dream Team


Print