Each of us tries to equip the house so that it was pleasant to return to it. Each part of interior has to not only be combined with each other, but also be used with the maximum share of usefulness. If to consider that in small premises each centimeter has to be used to the maximum, then it is worth paying attention to use only of qualitative and functional furniture. One of decisions is the back shelf made independently.
It is required to you
- material for production of the shelf;
- construction tools;
- fixtures;
- tape measure;
- simple pencil;
- sketch of the shelf;
- paint or varnish.
Instruction
1. Decide on that, where exactly in the house the back shelf and for what storage of objects (construction tools, family archive, newspapers, clothes, etc.) it will be used will be established.
2. Carry out measurements of the shelf. As a rule, it is necessary to carry out three measurements. It is flange width, its length and depth. It is worth paying attention that for keeping of big cargo, the shelf needs to be strengthened. For this purpose it is not obligatory to use thick plywood or board as from below it is possible to beat bar or two parallel not thick bars. All sizes need to be written down on paper, and only after that to transfer to material by means of tape measure and simple pencil.
3. Cut all parts according to the project of the shelf. They should be painted before assembly or after installation of the shelf. All parts on saw cuts should be smoothed out surely. After cleaning and fitting of parts the friend in relation to the friend, it is possible to start directly mounting of the shelf. It is the best of all to collect frame parts of the shelf on floor. For check of correctness of assembly it is possible to use the level and the measuring instrument of corners.
4. Collect side and back part (if that is available) regiments. Only after that it is worth starting production of overlapping of the shelf. It fastens nails of the corresponding size or corners. For simplification of collecting the shelf it is possible to use the screw driver. The lower part of the shelf has to fasten to all rest especially strongly as on it the maximum load will be given.
5. Attach to the shelf (side or top to parts) loops on which the shelf will keep. If the shelf is attached to stronger and big furniture, then it is worth taking care of its esthetics.
6. Check durability of the shelf, its part, fastening, density of adherence of all parts to each other. For check what loading this shelf can sustain, use the following method. Under the shelf put several boxes or big box so that the gap between the lower part of the shelf and upper part of the subject substituted under it was no more than 1 cm. It will serve as peculiar insurance.
7. Start execution of the test. For this purpose load the shelf approximately to that level which will be used by you. Start operation.