Install such useful device as the central castle on many modern cars. It enjoys wide popularity as life to the driver is considerably facilitated. It is possible to put the central lock independently.
It is required to you
- - 4 activators (one five-wire and 3 two-conductor - can be taken 2 strengthened, on back doors)
- - 2 relays on 40A with the wires having blocks.
- - 2 condensers on 1000 microfarad x 25B and 2 resistors on 4.7 kOhm
- - multi-colored wires, with a section of 1 quarter of mm.
Instruction
1. We make connection according to the scheme. Resistors and condensers need to be soldered together and it is obligatory to insulate. The insulating tape or thermocambric well is suitable for this purpose. Isolation has to be executed even before installation on the car of resistors and condensers. The five-wire activator is installed on driver's door, and two-conductor – we establish on all other doors. It is necessary to be engaged in adjustment of activators. For each car the activators are adjusted in the place individually. They fasten so that there was no movement of draft of locks. All mechanisms should be greased with liquid lubricant. It is the best of all to use at the same time silicone lubricant.
2. Each lock needs to be checked and adjusted. Everything has to work accurately. After installation it is necessary to check operation of each lock. For this purpose it is necessary to use the small 12-volt accumulator. However there is one problem which is that it is possible to close locks of front doors only at the closed other doors.
3. After connection is complete, it is necessary to check whether locks synchronously are closed. Quite often wires just mix up. If the alarm system with distant control is installed on the car, then locks have to open from it brelka. If the alarm system is absent, then doors will open only from key. It is the best of all to put the central lock in installation time of the alarm system.