Not all apartments are equipped with the winter fridge, but it can be made independently, then it will be possible to store pickles in it in the summer, and in the rest of the time to use space as the full-fledged natural refrigerator which will help to save the electric power.
In order that in kitchen to equip the fridge under window, it is necessary to prepare capacity for solution mixing, trowel, cement, sand, chisel, rubber cord, the perforator and heater.
Preparatory work
For arrangement of special niche for the fridge it is necessary to dismantle originally windowsill, as a rule, it is drowned in thickness of wall approximately on 2 cm and has fastenings which should be weakened. It can be carried out by means of rubber hammer, they need to strike windowsill from below. If after that it is not possible to take plate, it is possible to start the hammer and chisel, by means of these tools it is necessary to form space between wall and windowsill, hollowing out seal from solution and moving ahead down.
Now it is possible to pass to preparation of niche. It does not need to be done excessively deep, width of its external wall has to be equal to laying in one brick. Originally it is necessary to carry out marking, and on it to make perforation that assumes local drilling of openings on the line. Following on contour of the made openings, it is necessary to walk the Bulgarian. Then it is necessary to hollow separate elements with use of the hammer and chisel, at the same time it is necessary to level internal surfaces of niche.
Then in corner under frame it is necessary to form through hole which diameter has to be equal to 2 cm. At exit it has to be located under draining that will exclude hit in it of dust and precipitation. It is necessary to do opening by the perforator with chisel, the tool needs to be installed on the shock mode.
Production of the fridge under window
The niche has to be leveled by tie, for check of its flatness it is necessary to use level. Instead of old windowsill it is necessary to mount new, its thickness can be equal to 30 mm or more. The design needs to be recorded solution which has to be prepared from cement and sand, it is necessary to mix components in proportion 1:1. Several days later after solution hardening, it is possible to begin to equip fridge cabinet. The internal arrangement of elements can be changed depending on the preferences. It is admissible to separate space into 2 compartments, one of which will be warm, and the second – cold thanks to availability of natural ventilation. As material for doors and shelves the wood-shaving plate which thickness can vary ranging from 15 up to 20 mm will act. It is possible to use and has flown down for this purpose, its thickness has to be equal to 10 mm. In order that cold did not go to rooms, it is possible to order doors from plastic. Exterior of the winter refrigerator should not be beaten out from the general surroundings of kitchen, production of doors for this purpose can be ordered in the furniture company, having picked up facades, as on the headset. And here that in the winter they did not freeze through, they can be warmed from within, using mineral wool or polyfoam. Cotton wool has to be protected from above by moisture resistant gypsum cardboard. Doors on edges should be glued with rubber sealant, it will exclude penetration of cold into the room. Before fixing of cord the surface should be cleaned from dirt and dust, and after to degrease.