It is quite real to make smoking installation independently. For this purpose it is necessary to have near at hand the necessary tool and material. All this can be found in shops easily. Information of this article will help you to create smoking installation by the hands.
1. At the smoke-cured smoking shed very simple design. The main attention is paid to the smoking camera. This camera will be put on fire, gas or other source of heat which can give smoke on means of decay of sawdust.
2. It is quite real to make smoking installation of improvised materials. Very well the brick and boards is suitable for this case. Such smoking shed will remind cabinet with door. The cabinet becomes of 1 square meter, and height – in 2 meters. It is necessary to build flue. The chimney pipe has to have valve. In this peculiar cabinet it is necessary to establish crossbeams. On them products are placed then. To regulate smoking, it is necessary to establish several steps.
3. In any yard it is possible to make with own hands the smoking shed. It is necessary to be engaged in the center device for receiving smoke. Smoking installation can be made brick or other material which is not exposed to burning. Often use the wattle fence covered with clay for such purpose. It is possible to apply the boards upholstered with iron.
4. That smoke was evenly distributed on the camera, it is necessary to attach at distance 10 cm iron leaf. Under the smoking shed place most often sawdust. They have to be on iron pallet. Sawdust is smoke source.
5. The simplest smoking installation can be made even of two barrels. We put them at each other. Crossbeams fasten in the top barrel approximately on 10 cm from edge. On these crossbeams products for smoking keep within. In the lower barrel there has to be entrance for fuel materials. It is necessary to make fire on the earth. In it then throw up sawdust and coals. After smoke has gone, it is necessary to close the top barrel cover. In this cover there has to be opening.