Often people think of how to make with own hands wooden table. Business this difficult also demands special knowledge and abilities. At production of wooden table it is necessary to be attentive in calculations. If desired the table will turn out just magnificent.
Instruction
1. It is the best of all to do table of pine or fir-tree bars. Also plywood and rails is required. Plywood is necessary for production of table-top. Best of all plywood from 12 to 15 millimeters thick approaches. From wood materials, such as oak, maple or birch, it is possible to make the fixing wedges. At connection it is not recommended to use glue except for short rails of underframe and bars of foot. They fasten to vertical rack with the help of glue and screws.
2. It is necessary to fix table-top only by means of screws. It is possible to screw in them both from table-top, and from frame. The last way of screwing in of screws as it will be possible to make transparent lacquering of surface of table-top is considered the best. The table has to be about 750 millimeters high. If table-tops pays off on 6 people, then its sizes have to be about 750 X 1400 millimeters. It is possible to be engaged in creation of round table also.
3. The table-top of round table is cut from 10-, 12- or 15-millimeter plywood. By means of nail it is necessary to draw circle on veneer sheet. It is also possible to use pencil. Then it is necessary to cut crenulate "vykruzhny" (narrow) saw. The edge of this circle needs processing. It becomes by means of large and thin emery paper. Such table has height about 730 millimeters, and diameter of table-top of 700 — 800 millimeters.
4. The crosspiece of underframe and legs needs to be done of bars which have the section of not less than 40X50 millimeters. To increase the sizes of support of table, legs need to be strengthened in the underframe crosspiece slightly obliquely. The corner has to be about 95 — 100 °. Legs of table fasten on glue to slots of the crosspiece. Slots can be hollowed chisel.