Today digital keyboards accompany the person everywhere therefore practically everyone can handle the electronic digital lock. And here to be as equals with the mechanical coded lock, some skill and practical knowledge is required. The mechanical locking devices demand to themselves quiet, measured and even thoughtful relation.
Instruction
1. Let's review specific example of set of the code on the mechanical coded lock. Let's assume, on the device code 75-39-12-04 is established. The turning part of the lock turn (limb) on four whole revolutions that the first of the code (75) has passed by tag three times, and on the last, fourth time has stopped exactly opposite to tag.
2. Now scroll limb in opposite direction so that the second of the code (39) has twice passed by tag, and on the third time has stopped strictly opposite to it.
3. Scroll mobile part in the opposite direction so that the third (12) once has passed by tag, and on the second time has risen directly opposite to it.
4. Repeat operation in other party, that is just put the last number (04) opposite to tag. The code is typed in full accordance with procedure conditions.
5. Consider that depending on design of the specific lock of operation can differ from described a little. So, numbers can be three, but not four. In this case the first is gathered not four times, and three times. Sometimes in locks with the replaceable code after set of the sequence the limb is required to be turned in addition in the opposite direction against the stop. In general the sequence of actions remains approximately to the same.
6. Consider that depending on design of the specific lock of operation can differ from described a little. So, numbers can be three, but not four. In this case the first is gathered not four times, and three times. Sometimes in locks with the replaceable code after set of the sequence the limb is required to be turned in addition in the opposite direction against the stop. In general the sequence of actions remains approximately to the same.
7. If you have by mistake overwound mobile part, then it does not make sense to correct it, turning back. Just type the code anew. As you understand now, at handling of locks of this kind the accuracy, attention, full concentration and clearness of actions is required.