White boots look very effectively, but, unfortunately, are quite not practical. They are quickly soiled, lose elegant look, demand more thorough leaving. If quality of footwear at the level, but you were bothered by color, just try to change it. It is not difficult to paint white boots, but success will depend in many respects on respect for technology and the correct selection of materials.
It is required to you
- - nitropaint, acrylic paints, skin color ""Extra"", NTs-36 enamel or other paints;
- - tampon, brush, air brush.
Instruction
1. If you need to paint leather boots, carefully pick up paint. Use special nitropaints, at the same time surely attentively read application instructions. Are very convenient in use of paint in aerosol cans as allow to receive even thin layer. It is checked that NTs-36 enamel and skin color "Extra" give good effect.
2. Carefully clean footwear surface, wash up boots with soap and dry up.
3. Take nitropaint and add to it one-two drops of castor oil to make it more resistant to cracking. You put it with brush, gauze tampon or air brush. After drawing the first layer you dry boots within hour and put the second layer. For creation of more bright color add the third layer. Finally it is necessary to dry surface within a day.
4. If you have decided to paint white leather boots with nitropaint in aerosol can, keep spray head at arm's length of 15 - 20 cm from surface and quickly move cylinder. Then dry skin of 10 - 15 minutes and put one more layer. So repeat until receive uniform strong coloring. After skin dries out within hour, remove flows and flow paints if they have appeared.
5. It is possible to paint white boots acrylic paints for fabric, but consider that skin will become more rough as will become covered by film. You do not put more than three coats of paint to avoid cracking.
6. Paint for white boots can be made independently, for example, on the basis of multi-colored ink or aniline dyes for wool. Mix them with gelatin and you apply on surface. For small drawings try to make paint on the basis of paste for ball pens, for this purpose cut rods on pieces and fill in with suitable solvent, for example, No. 646 or KR-36.
7. For coloring of suede white boots use aniline dyes of wool. Take the distilled or melt water (for example, from the freezing chamber or from snow) and dissolve bag of aniline dye (on one bag 1.5 liters of water are necessary). Temperature of solution should not exceed 45ºС, otherwise suede will lose durability and elasticity. You apply warm solution and evenly rub brush in suede. Repeat operation in 20 minutes, gradually adding vinegar to paint. At the end wipe boots with vinegar solution, wash out in water and dry up at the room temperature. In the same way it is possible to paint white suede boots by means of Rainbow ink.