Serpyanka prevents cracking of the surface covered with putty, it is irreplaceable for processing of joints of sheets of gypsum cardboard or other slots, cracks, corners. In spite of the fact that the technology of sticker of serpyanka is quite simple, it is necessary to consider some nuances.
It is required to you
- - serpyanka;
- - scissors;
- - knife;
- - putty;
- - glue (bustilat, PVA, acrylate, etc.);
- - palette;
- - abrasive paper;
- - primer.
Instruction
1. Prepare surface for reinforcing, carefully clean it from dirt and dust, degrease, remove spots and roughnesses. If necessary to zashkurta also remove shabby coverings (old paint, wall-paper, etc.) mechanically. If smooth surface, its progruntuyta for improvement of skhvatyvaniye.
2. Or close up Zashpatlyuyte the leveling structures (glue, plaster, cement) cracks, time, joints, corners or other defects which is subject to stick with serpyanka. Dry also to zashkurta after drying.
3. Apply on the place of sticking up adhesive layer (bustilat, PVA, acrylate, etc.) or liquid putty by means of brush or the roller.
4. Cut off piece of serpyanka of the necessary size and paste it on the processed site. Level material the palette or big brush-maklovitsey.
5. For more reliable skhvatyvaniye wet serpyanka in the diluted glue (8 or 9 parts of glue, the rest - water).
6. For seal of joints of plasterboard plates paste serpyanka without glue. For this purpose part putty to density of sour cream without lumps and apply it on seam. Then accurately attach the cut-off film of serpyanka to seam and press it into the put layer that it has completely become impregnated. Pay attention, you should not paste over thus big surfaces, the putty will not be able to provide sufficient reliability.
7. After the serpyanka takes the place and will dry up, completely to zashpatlyuyta surface. Gain small amount of material on the palette and you apply it with smooth movements on seam, without applying great efforts. You hold the palette so that the corner between the internal plane of the palette and surface was sharper that mix was imposed evenly, but it was not pressed into seam.
8. Dry during the time specified on packing with putty, zashkurta. Remove the formed cambers on surface with sandpaper next day. Apply primer and finish surface – paint, paste over with wall-paper, etc.