Flizelinovy wall-paper — fine option of finishing of walls. It is caused by their decorative qualities and relative simplicity of pasting. Even the beginner in the field of repair will be able to cope with this mission.
In hardware stores it is possible to meet flizelinovy wall-paper and wall-paper on flizelinovy basis. Wall-paper of that and other look is issued with the drawing and without it. It should be noted that wall-paper without the drawing assumes their further painting.
Preparatory work
The room in which it will be repaired should be freed from furniture. If there is no opportunity to take out furniture, then it is shifted in the center of the room, having provided, thus, free access to walls. Before paperhanging of wall it is necessary to clean from former finishing. They have to be equal. Alignment is made by putty. After the putty dries, all convex places are rubbed clean abrasive paper so that to exclude roughnesses.
The next stage — primer. It will help to clean walls from dust and to save glue. Thanks to primer, wall-paper will be better to stseplivatsya with wall. After the wall is ready, it is possible to dissolve glue. Glue should be bought with mark "For flizelinovy wall-paper" or "For all types of wall-paper". Clay gets divorced according to the instruction on packing.
Technology of pasting by flizelinovy wall-paper
For a start it is necessary to measure wall height. From roll of wallpaper to cut off the front page 10 — 15 cm bigger, than wall height. The second and the subsequent parties are cut off from roll taking into account adjustment under the drawing if it is available. When pasting the room flizelinovy wall-paper glue is applied only on wall. It is possible to do it by the roller or wide paint brush. Pasting begins with room corner. Here wall-paper is glued with an overlap. That is the strip of wall-paper has to come on 1 — 2 cm on the second wall of corner. It is necessary to put strip of wall-paper to wall from top to down and at once to smooth it from the middle of cloth to edges. It is possible to smooth with the roller or piece of pure fabric. The special attention to edges of strip — them needs to be pressed down better to wall surface. For this purpose it is possible to use the special roller. The second strip of wall-paper is glued already end-to-end. Flizelinovy wall-paper is good the fact that when drying they do not contract therefore seams will not creep away. Excess pieces of wall-paper near ceiling and floor should be cut off stationery knife. If wall-paper is acquired under painting, then after all room is pasted over, it is possible to paint them. Aqueous emulsion ink is intended for flizelinovy wall-paper. It can give color by means of color. It is necessary to dissolve paint so that it was enough completely for all room. Otherwise color will be difficult to be picked up. It is easy to work with flizelinovy wall-paper and if to choose finishing option under painting, then it is possible to change color of walls, without resorting to new pasting of the room wall-paper.