Preparation of shish kebabs and barbecue is the settled tradition practically of any departure on the nature. Therefore the good hospitable owner, as a rule, tries to get brazier on the country site. To put brick brazier the hands - task rather difficult. But if you have some idea of brickwork, it is possible to try to make brazier independently.
It is required to you
- - red oven brick;
- - grid from metal wire;
- - plate from sandstone;
- - solution for laying;
- - box for coal;
- - drill with drills on concrete;
- - palette;
- - steel rods of square section;
- - hammer;
- - solution for consolidation;
- - construction level;
- - capacity for solution;
- - means for washing off of cement smudges
Instruction
1. Develop and draw the project. Choose the place for brazier. Prepare base slab and apply on it brazier outlines. Lay out bricks, without putting solution. Carefully to vyverta also note right angles.
2. Lay out the first layer of laying on solution so that between bricks there were equal intervals. Check laying by means of construction level.
3. Lay steel rods between the first and second layers of bricks. Thanks to these rods you receive accurate identical seams. Lay out the second layer of brickwork. Remove rods and transfer them above.
4. Lay out brazier walls by analogy with the first rows of bricks. It is necessary to consider that each layer of brickwork needs to be verified carefully by means of construction level. At detection of roughnesses - level laying by means of the special hammer.
5. Wait for full drying of solution. It is recommended to start the next stage of works not earlier, than in three days.
6. Clean brazier walls from dust. Remove surplus of solution by means of special means. Carefully check all seams of brickwork for availability of emptiness.
7. Drill in opening brazier walls under fastening bolts on which will be fixed box for coal and grid for grill. Fix basic bolts so that they acted from brazier walls on 3 cm.
8. Establish box for coal and grid so that they leaned on bolts.
9. Apply solution over brickwork, on all perimeter of walls of brazier. Solution should be applied pointwise.
10. Lay plate from sandstone on solution. Let's solution dry out. Your brazier is ready.