The operation principle of paktronik is that sensors of paktronik measure distance from obstacle to car bumper by both light and sound signals warn the driver about dangerous proximity. Paktronik includes: the control unit, the indication block, sensors (generally 4 pieces in set), mill for drilling of openings under sensors, feeder cables, connections, communications. Usually sensors of paktronik establish in openings of rear bumper, the control unit fastens in the same place, under rear bumper, the block of indication is brought in salon to mirror or to fasten behind on the panel.
Instruction
1. Buy in autoshop paktronik of the chosen model and attentively read the instruction. Mark arrangement of sensors, following the instruction. The enclosed mill drill in bumper under the license plate of opening for sensors. Distance between two middle sensors usually 50 cm.
2. Accurately remove inside machines trunk covering. Install sensors in the drilled openings, accurately tracing order according to the instruction and marking. Rigid wire drag wires from sensors in bumper car.
3. Stretch wires from bumper through opening in back wall in trunk. This opening is usually closed by rubber stub. It as it is impossible more, is suitable for installation of cables. Connect wires to the control unit. Attach the control unit on double-sided adhesive tape on inside of back wing.
4. Remove the indication block in salon. If it is necessary to carry out wires to the front panel (the front indicator is chosen), carry out them under thresholds of doors. Attach wires from the block of indication to the control unit according to the scheme of the instruction.
5. Connect the control unit of paktronik according to the instruction, using the system of connection of lamps of backing.